Recent content by Sinister#4

back in the day in hot Arizona on my K1200s Id wear out a soft rear in 1000 miles or less, front about 2000.......but I was younger and the roads were hot and twisty lmao

its not bad at all, just get the filter wrench and some of the plastic tools

well after checking a LOT the 2024 part number washer 09168-10002 this is the really odd one in the pic above i`m guessing this has replaced the 14004 and the 14002 washers that most seem to be using ?

Ordered new drain plug gaskets, there seems to be 2 different ones 09168-14002 and for the 24 09168-10002 the latter is the thick looking thing that compresses a bunch then tightened, now what is the better one ? Checked and both numbers show for the busa ? thanks !

Got the new exhaust installed, fit and finish top rate no issues and sounds nice

Very good podcast for sure, Back in the day I bought a gs1150ES (first one in AZ) ride it as my day to day transportation. Yosh full system and carb rejet. I loved that thing, it did everything (for the time) well the gen 3 is like that now. I also still have my BMW k1200s, another "just does...

Road totally suck up here so got a TRX

Did the knight 1 inch drop, nice pegs and any lower than 1½ inches you may not be able to adjust the shifter ect properly just my 2 cents

you can mill it

Heres the cut needed to allow the shifter side peg to clear using the knight design gen 2 pegs. The pegs actually go on with NO cut but it will NOT fold up with out hitting the shifter pivot, so a small cut is needed

Still waiting on exhaust gaskets to install my system, checked with partzilla, yeah there are in stock, ordered some 2 day, then "sorry not in stock ordered from supplier" I cancelled the order, sad they dont really know what they have on the shelf. Did get a set of the knight design lowering...

Soon as I have a look at the actual wind tunnel data and all test results i`ll think about them......................................no data, no sale. This bike is stable as a rock at speed, nfw id bolt any untested aero on it for looks. And ill agree with the BMW 1600 data, grand america is a...

63 here lol

Id drain it and refill.....is it oxegenated ? if so very unlikely it would have water as the alky and water would mix (unless it has a LOT of water in it)

Yeah really if any traction (or abs) is on you may get a very small "blip" of power loss, it reacts damn quick