Recent content by OB_RPM

This isn't, I don't think, a Hayabusa question, but I need to know who makes a good adjustable high pressure fuel regulator?? This is for a GSXR750 with the 815cc big bore kit.

Can you reply me your mailing address here? [This message has been edited by RPM (edited 11 August 2000).]

Have misplaced your number, need to talk to you about something, I think you'll be very interested in. Can you either email it to me or call me?? robertpmurphy@verizon.com 617-227-6969

Good point. Dave, you get home ok last night??

These are from Performance Friction: http://www.performancefriction.com/Catalog/Powersports/Cycles/CyclePartsFound.asp As far as the rears go, who uses the rear brakes?? The answer is actually they have not yet developed rears for our bike. I also should mention that they have them for other...

Remember, this was a fix for my problem, and I only did it to get it working until I figure out why the voltage is so high. I put the resistor between the green and blue wires coming up from the CPS, at the connector. I'm starting to think that maybe the chrome plating on the side cover may...

Thanks Dave.

Let the header melt the small section that it will melt, mine took only a couple of rides to stop melting the underneath part at the rear where the 2 sides meet. If you use header wrap it will most definitely rot out the tubes the same way it does on car headers. I tried the wrap on a few...

I'm not done yet, I'll keep everyone posted.

You the Man!!!!!!!!!!!!!

Anyone want the best pads and/or hose kit available? Want to be able to decrease brake pressure as you slow down because you don't need every last bit of your brakes capacity to just come down from the balistic speeds that your Bus can produce? Well I have the pads and the hose kit for you...

Yoshimura I believe makes a high pipe and a bracket as well, but Daveo could probably confirm that for you.

There's already a large quantity of babble regarding the PCII on this board, but I felt this one needed to be heard. I was not able to run my bike with the PCII. For those of you who are not familiar with my bike, it's a '99 w/Akra full exhaust, no PAIR valve, and a BMC filter. When I added...

No problem. I'd be more concerned with getting a set of these pads in your bike though. They will singlehandly make the most improvement.

All hardware ie: bolts, banjos, etc. are steel with an iridite type finish.