I am getting a clunging sound at the rear from the chain side of the bike when pulling away and shifting in the low gears? Any Ideas what this is? Chain is set OK with the right amount of slack!
Also so has any one found a way to stop the low speed buzzing sound that you get on the left-hand...
bammbusa
You can always import a Black/Gray from the UK. I imported one last Feb through the net - just whent to the suzuki Uk site got a list of dealers, sent a few e-mails to compare prices and charged it to my credit card. Cost £6,200 = approx $10,000. By airfreight it was here in 4 days! Out...
Well the FI light came on again today! So with out stopping the engine I flipped the Mode switch and got this code - C27 (with the bar/dash at the top)? Any of you guys know what this means?
This is the 3rd time that the light has come on in the last 3 months! But it only seems to happen when I...
Just put a set of TapeWorks Hayabusa decals in florescent orange on to my Black and grey Busa, looks real cool and defiantly gives the bike a different looking attitude! Funky I guess is a good description! Has anyone else used these decals from TapeWorks in different colour schemes? The quality...
Well after all this talk and mind mending chat! I ordered a copy of the service manual today, as I guess it would give me more direct answers.
But thanks anyway guys for all your input and pointing me in the right! Or was left direction!
So does any one know what this code means (bar at top captial-COO)? As I do not have a service manual yet? Where can I get a service Manual from in english! who will ship by UPS to Egypt?
The 'MODE SELECTION SWITCH' part No 09930-82710 I got in Toyoko for Y920 = $8.50
The FI light came on the other day! So I stopped the bike switched off and back on again and it was OK again and has been normal since? Anyway I got hold of the diagnostic switch tool and connected it up today and the reading is as follows -COO ... with the bar at the top? Any of you guys know...
I am running the following map - M304-503 for European version bike with "race only" slip on mufflers and stock air filter with modified table 3 +5+5+5. Stuttering 1st & 2nd gears around 3000/3500 revs.
Map for Yoshimura RS3 Race Only slip-ons EHas anyone got a customised map or a PCII modified map to over come the stuttering in low revs / gears. Would appreciate any help Ee-mail ed_bud@hotmail.com
[This message has been edited by Busbusa (edited 03 May 2000).]
Low rev. Hesitation / Stutter with the RS-3 Race Only slip-ons, seems to have gone now that I re-mapped the PC II using map (M304-004.map for Yoshimura race only duplex full exhaust system with Stock air filter). I haven’t yet taken the bike out for a high speed /rev performance check yet? But...
Motorhead
Thanks for the info. But as I am no technical head and only just learning about FI (No dealers or mechanics to ask or assist you here) can you just explain a bit more….. What do you mean by bottom? Are you referring to the lower Throttle openings in Table 3 or Table 1? And no I have...
Interesting …I have recently installed the PC II and re-mapped for the Yosh RS-3 race only slip-ons. Experiencing a hesitation / stutter between 2000 & 3000 rpm's in 1st and 2nd gears? (Any solutions guys?) Otherwise a definite improvement.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.