Recent content by busacharged

I have a standard hahn kit for the moment, but will soon be adding a turboxs boost control and blow off valve, who makes a higher flowing fuel rail, and injectors. I cant seem to find much on them. thanx, b.c.

Are there any other good control boxes for fueling and retard other than the pc3r I think mines a piece of shat. thanx busacharged.

Can I add a wastegate, boost controller to my base hahn kit. And what do these things do? How would they affect the kit.And another question, I run my k&n inside the fairing is it possible that it could starve for air, what would symptoms be for poor airflow, should I cut the fairing for the...

I recently installed a hahn on my 03 and had some minor fuel leaks, and later on an oil leak at the same fitting in the pan, I fixed the leak with teflon tape and a light coat of gasket sealer on the threads. fuel leak was fixed with teflon tape. hope this helps, busacharged.

Yeah, I have the oil cooler bypass hose on mine .The oil cooler ports are just used for bypass, the oil feed is off of a small plug on the lower right side of the engine, hahn supplied a fitting to replace the stock one in the motor, the return line fitting was the most challenging part of the...

Its a good system, but I ran into some snags when installing it, the instructions didnt cover everything, you might run into but, it was nothing major, I dont have any turbo installers here so I had to do it myself, if someone does it for you then youre fine. but overall its a good kit , very...

Its a hahn stage one, Its my first turbo so I wasnt sure about oil being in there, but with the heat generated down there it might be a good thing. I just wish Hahn would hurry up and make some upgrades for this thing. BTW is nlr's shop in alabama and do they dyno tune turbo bikes I need to have...

Ive got a black/grey 03, but if the price is right Im interested anyway. The extra plastic may come in handy some day. Once I figure out this digital camera I got for christmas Ill post pics. how much $$$$$$$$. thanx,bcharged.

I took off my k&n today to inspect it and inside the inlet where the impeller was a coating of oil ,also inside the filter, should there be oil there? or do I have a seal leaking? It wasnt from the filter either. Its not in the boost tube at least not yet.thanx, busacharged.

If I took, say a muzzy billet big block which he says with a +7.5 stroker crank will come out to 1661 cc and built the motor, then reinstalled the turbo, to lower the compression in a setup like this would a spacer be good enough (13.1) or would I need turbo pistons and a spacer. This is an...

Thanks Doc for the pics, it does kinda suck where it darkend the fairing, just let me know when your ready to sell, because im still interested. thanx, busacharged.

Hey doc do you still want to sell the coated dump, cause im still interested. thanx bcharged.

It will eliminate the bottom end jerkiness, and youll like the extra take off, just watch the neck snap! It really wakes it up. but not like turbo hehehehe! later bcharged.

I used to run an Ivans on my 2003 it cleaned up the jerkiness in the bottom end and seemed to help the bottom end takeoff and maybe a little stronger mid range, I did experience some idle issues it seemed too low sometimes but after raising it it did ok, I have a hahn turbo kit on it now so I...

N.E. where can i get the halmeter/ a/f gauge, im running the boost and f/p already. thanx, bcharged.