Recent content by barkleyw

I have a built up 1999 hayabusa - am new to this. I keep burning clutch plates up - put in stiffer springs, brought the stack height up to 1.98-2 with wider steels and I still am slipping them. couple questions - whats the greatest stack height I could go with and... what would be the most...

delete this post - my bad - my dang throttle cable was pinched in my handle bar - every time it turned to the right it reved up...bonehead move...live and learn.

just got my bike out of storage...started it up and it ran fine. Started it up again and the throttle is wide open. I had to shut it down right away - tried a few more times and wide open every time. it has a power commander 3 on it - I plugged in my laptop and I guess I cannot check the...

Thanks...I will look it up..trying to find the specs on it.

Can anyone tell me the brand of this exhaust system?

Thank you again! Time to do some googling.

Speaking of rear pegs - I took a closer look at my bike on where I would like my foot placement and found these mounts - are these stock mounts for pegs? I believe this bike was drag raced prior - perhaps this is where he mounted them. It seems like a set of screw in pegs would work well for...

Excellent info - thank you Dennis! Interesting on the wheel base size - I will have to look into that. As far as I know mine is all stock. I need to get a strap for it - any suggestions? its a 99 busa. Also - I have a Power Commander 3 in it and want to set up an air shifter with a quick shift...

I will going to the Wisconsin International Raceway in Kaukana, WI. My goal is to see how fast I can get it going without a wheelie bar, and just some basic mods. So, if I understand you right - it sounds like for the ET racing I can do whatever I want to the bike and I do not have to worry so...

I picked up a bike a few months back to start drag racing - I live in WI so I have all winter to prepare and I have a lot of learning. The track i will bring it to follows IHRA rules so I am trying to make sens of it all. Am I correct in that Pro-Street you can't have wheelie bars but you...

good idea on assuming its stock....I paid just over 4k for this one...11,500 miles. came with the PC3, no cracks in the plastic, not sure if the K&N filter is stock but it was on there also. Once I get the dyno run I will post it.

convinced - I will bring it in and get dyno'd

Do you know if the entire exhaust is aftermarket or just the muffler/silencer section - I will have to see if there are any markings on it.

Here they are...is that a stock exhaust - it does have a PC3 - wondering why they would have that if this is stock? I will take a peak behind the throttle bodies - not sure if I want to take the exhaust off. The guy lowered it in the back and the horn is disconnected - air shift maybe...

Thanks guys - I will take some pics and post......