Recent content by badass1000

are you going to drag race it? check out www.northwestdragbike.com several good racers that tune. do you have a data logger on it? is the bike stock height/wheelbase or is it lowered and extended?

I have a nlr sim in my turbo busa and it seems to work great. It has always had a sim on it since it has ben turbod though. so I can not tell you how much better it is then stock. as far as plugs about every one I know just runs cr9e's without any problems. Cheap and easy to gap. I pull...

if you had a mtc multi stage and it rattled like a ducati dry clutch you had something seriously wrong with it. I have ran several and non of them made any noise different then a stock clutch.

So what size was it? Just curious.

Cut and paste from eatmyink.com. posted on facebook. The DME rental bike that Ehren Litten rode this year has been stretched to 75 inches, fitted with a bigger turbo and shod with a small slick, as per Arabian League rules. Joey Gladstone ran 6.71 at a whopping 224 mph on the bike. Look out...

your talking about the finals. the video. It was a bar bike vs non bar bike. the bar bike gets all of its e.t. in the sixty and up to the 1/8th. I have not seen the time slips, but I bet the bar bike was barely ahead at the 1/8th. Non bar bike probably has a lot more hp and is a lot...

any time I am looking at a bike I just assume it is a stock motor and pay accordingly. If they want extra money because the motor is supposedly built I want proof. Receipts and a dyno run to back it up. Even if it does have parts they can be a huge difference. a 1397 could make between 165hp...

What is it supposed to max out at for HP?

Is the oil scavage pump required? Will it drain fine without one? Looks very nice. I want one. :)

I have a McIntosh IB pro arm sitting in the garage that has the catch can setup similar to what Ragu585 has. I have a McIntosh IB pro arm on my street turbo busa, but it does not have the breather setup on it. the motor in it now has a stock bottom end that has never ben apart. I have quite a...

unfortunately catalyst is not the greatest quality. Do not expect show quality or perfect fitting parts for sure. Kind of a lack of competition. I have purchased for myself and friends 4 gen 2 catalyst extended tails. one +8 super sport tail and 3 +6 street tails. I do not have passenger pegs...

You got me rolling on the floor laughing. Now that you have that ecu modded to the max and you can't mod it any further without blowing it up you need to get yourself a couple of these wired up in series: "HP Dyno Boost Performance Chip Part Suzuki GSX 1300 R Hayabusa 1400 EFI | eBay" now you...

The AEM E85 Fuel Pump is designed for in-tank installation on high performance naturally aspirated and forced induction vehicles. first sentence of the description of the pump. How are you going to hook a fuel line up from the tank to the inlet of the pump?

I messed with my busa earlier this year. their is only one adjuster in the center. 1-2 are fixed with no adjustment and 3-4 are fixed with no adjustment. so when you balance them you are only balancing 1-2 to 3-4. The isc only has one solenoid that opens or closes the passageways to all the...

Lol... I deal with this same **** all the time. I do HVAC for a living. I was at a house at 7 last night. $69 service call to see what is wrong. it had a bad stat. I tell them $69 installed for a stat. homeowner says they can buy a stat for $20 at home depot and install it themselves. I...