dubbedmarquis98
Registered
hey guys i just installed the 1" risers and it was a breeze. now how do i pull the forks up and how much? i have a rear stand and a front stand that the "pegs" sit under and behind the forks. pleze help
Quick Question
- Thread starter dubbedmarquis98
- Start date
Lossen the clamps slowly and let em slide through till the stop at the top tree. You can usually loosen 3 of the 4 total clamps and then use the 4th to control the slide.
Even with the bolts backed out it takes a bit of effort to knock them up or down...it may help to use a sharpe marker / tape to show the left / right fork tube change...just to keep them the same...if you have a digi caliper or gage that will also prove the l/r being equal
dubbedmarquis98
Registered
thanks for the help. im using risers so wouldnt the forks slide to the bottom and they would be equal, and no worries?
Probly, measure just to be sure tho.
I just let my slide to the tripple tree. I assumed they were equal. Never had an issue. 
but I am a redneck engineer 
but I am a redneck engineer Similar threads
