dewie
Registered
I'm about to lose my mind here and I need some help. I'm not the best guy for the job when it comes to wiring and I think I might have fried my ECU. I was doing some rewiring to my pass flash switch and I mixed up a couple wires. The bike was on and then it went dead and I heard a pop from rear of the bike which was odd since all the fuses are up front. My pass switch was stuck down and I though that was my issue but now I'm thinking it arched itself together from my botched wire job.
Anyways Goldenchild has a switch for me (thnx bud) and I looked at all my fuse's and they are all good, how can I tell if I fried my ECU? Is there anything else I should be looking for that would cause that? The bike won't turn on, no lights, no fuel pump priming, nothing..
Any help is appreciated
Anyways Goldenchild has a switch for me (thnx bud) and I looked at all my fuse's and they are all good, how can I tell if I fried my ECU? Is there anything else I should be looking for that would cause that? The bike won't turn on, no lights, no fuel pump priming, nothing..
Any help is appreciated