Rear wheel torque...

[yamahor]

So, I gotta adjust the chain and forgot what the torque setting is for the nut on the axle... Any help? I wanna say 72 ft/lbs, but can't remember.

 

[kromdom]

Any help? I wanna say 72 ft/lbs, but can't remember.

I'd say BINGO (72.5 ft-lbs): https://www.hayabusa.org/forum/main...3965-gen-1-list-torque-values-most-bolts.html

 

[BA BUSA]

Posted via Mobile Device

Front and rear 72.5 ft lbs

 

[yamahor]

Muchos Gracias Amigos! I thought so, but wanted to double check.

 

[scrappy]

im gonna have to check my haynes manual.. it said 100lbs... i thought that was a bit high..

 

[BlueHaya]

im gonna have to check my haynes manual.. it said 100lbs... i thought that was a bit high..

That could hurt the bearings a little.

 

[Ludicrous Speed]

Actually, it should not matter, since the spacer makes sure you get the crush right every time

 

[07vigorblue]

i always torque mine to 100#'s

 

[StromBusa]

I thought I'd see a dyno chart

 

[majestic12]

It is 100 n-m = 72 ft-lbs. Not sure what the extra torque would do to the rear wheel. - source is the GEN II manual.

 

[2006busa]

I thought I'd see a dyno chart

i thought it was to

i always just torque mine until its tight and then line up a cotter pin hole on the nut and i didnt notice any problems with it

 

[dadofthree]

Hand tight for you tiny