Need a DIY idea for exhaust bracket

[SHIRO HAYABUSA]

Thanks to the classifieds and Piperfighter for my new/used Brock's exhaust. I got it installed today fairly easily; however, I can't seem to fit the bracket for the can to my swingarm. There isn't any place to bolt to. Any suggestions?

 

[SHIRO HAYABUSA]

Nothing

 

[Twobrothersbusa]

I wouldn't recommend trying to bolt anything to that swing arm....it moves ya know. Do you have any stills of exhaust mounting bracket on the pipe?

 

[Twobrothersbusa]

Looking around at some pics on the web, you are going to need the rear footpegs mounted for an exhaust mounting point.

Here is a link to a pic....

https://www.hayabusa.org/forum/engine-performance-mods/98287-brock-megaphone-installed.html

 

[SHIRO HAYABUSA]

Looking around at some pics on the web, you are going to need the rear footpegs mounted for an exhaust mounting point.

Here is a link to a pic....

https://www.hayabusa.org/forum/engine-performance-mods/98287-brock-megaphone-installed.html

Thanks TwoBrothersBusa, I didn't realize my question was a stupid as it was. I found a similar pic and laughed for a good 5 minutes. Thanks. back to lurking

 

[Twobrothersbusa]

Not stupid....just wanted to make sure you were thinking that one through

Good luck and for sure give us the finished pics!

Thanks TwoBrothersBusa, I didn't realize my question was a stupid as it was. I found a similar pic and laughed for a good 5 minutes. Thanks. back to lurking