HELP -02 BUSA Will NOT RUN, Where is the crank position sensor..?

[chat_vmax]

Hello all,
Im posting for a friend with a 2002 busa,,,
all stock..
BUT he decided to put a after market cover on in place of the stock stator cover,, after he buttoned it up it will not start,,

Motor cranks and backfires out the exhaust,,
Questions:
1: He removed the stator and put it inside the aftermarket cover,, is there a crank position sensor or something built into the stator,,,?

2: is there ANYTHING under that cover that can cause a timing issue... that is what appears to be the issue..

He is very dilegent and has sworn there is NO pinched wires or anything and asked me the above questions,,,
I told him i would post but thought thatthe bike would run without the stator even plugged in,,, ??

SO what could be the issue....

Thanks for your

 

[delbert]

the sensor is in the alternator cover & is actuated by a trigger on the alternator rotor , personally i would go back to basics & remove the cover and retrace his steps ie check the trigger for damage , trapped wiring , has the stator been fitted correctly to the cover ,

good luck

 

[chat_vmax]

u guys are the best !!!

You called it...
The stator cover was bad / made incorrectly...

We put the orgional stator cover on and she fired right up...!!

Thanks Again....

 

[Postal]

I've seen this before. Glad you discovered what was wrong.

P.