Frame Slider Hole Edges

Vonderbach

Your AD here!
Donating Member
Registered
I will be intalling my frame sliders this weekend (time permitting) and have been thinking of ways to pretty up the edges of the holes I'm going to cut. I found some rubber grommets at MSC and wondered if anyone had tried these or if there is a better suggestions out there?

1-5/8 ID Rubber Grommet

This will be a tight fit, but I think it will work. Thoughts?
 
Whatever you do make sure that you take your time and measure twice, cut once. I was not happy after I did mine and wanted to sale the bike afterwards, lol.
 
Roger that! I'm going with the laser pointer method, so hopefully it works out.

Dolilind, that was what I had considered originally, but I'm real fickle about making things look stock. Do you like the look?
 
I think the Grommets will look good

When I built my last show truck I ran all the wires through the boxes frame and out the back through rubber grommets, Looked very nice and clean.

===================================================================

000_0342.jpg


000_0346.jpg


000_0347.jpg
 
That's a good idea but just know your holes might come out so good you don't feel the need to use anything! I'm certainly not the master craftsman but I took my time, used blue tape over the surface, and it came out just fine. Good luck. Raydog

P1010554.JPG


P1010555.JPG
 
Back
Top