guys...i was trying to do the fender eliminator by using "jokers method" removed the rear reflectors, but the nuts are behind the this plastic base. i need to remove it, does it just snap out or is something holding it down. thanks for any info and advice...
The pins on the underside of the tail, 4 of them, two per side, push in the center of them with a ball point pen, or whatever you see that will fit. and push them in no more than 1/4 inch. then pull them out with your finger nails
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.