rustysprocket
Registered
Hi,
I'm after an Engine MAP or advice about a reliable MAP for a standard Gen II engine in a LeMans type chassis/body work race car.
It has a 4 into 1 ceramic coated header exiting via can through the body next to the engine. It has a large air ram above the bodywork.
It uses standard 98 octane Australian fuel (BP Ultimate).
The Gross weight with driver is 530kg.
An emphasis on reliability over maximum performance is vital.
Can the Ecu editor auto tune facility generate a suitable MAP? Is this done while driving?
What type of switch do I need to allow for the use of the 3 standard MAP setting as on the bike- wet, sport, race?
Are there any MAPS available to download for Australian bikes?
Is it possible to find out about the engine numbers and the year of manufacture etc?
Ta,
Rusty
I'm after an Engine MAP or advice about a reliable MAP for a standard Gen II engine in a LeMans type chassis/body work race car.
It has a 4 into 1 ceramic coated header exiting via can through the body next to the engine. It has a large air ram above the bodywork.
It uses standard 98 octane Australian fuel (BP Ultimate).
The Gross weight with driver is 530kg.
An emphasis on reliability over maximum performance is vital.
Can the Ecu editor auto tune facility generate a suitable MAP? Is this done while driving?
What type of switch do I need to allow for the use of the 3 standard MAP setting as on the bike- wet, sport, race?
Are there any MAPS available to download for Australian bikes?
Is it possible to find out about the engine numbers and the year of manufacture etc?
Ta,
Rusty