power commander Help!!!!!

[solarbarack]

I've always loaded my maps while the bike was on. I tried to update my firmware and the bike died. does any one know what prong is the hot and ground on these? I only need to power it long enough to update the firmware.

[solarbarack]

I tried running it without it and the bike doesn't run well at all.

[Professor]

Bump the idle up a bit. 95% of the time I swap my maps with the bike running.

[solarbarack]

I wasn't switching maps I was updating the firmware. The process started then the bike cut off, and it never finished the process.

[Professor]

Originally Posted by solarbarack @ Jun. 05 2008, 7:57 PM

I wasn't switching maps I was updating the firmware. The process started then the bike cut off, and it never finished the process.

My bad.... yep you have to have the battery for that. Hang on and I'll look at mine to see what the pins are.

[solarbarack]

Thanks a ton.

[Professor]

Don't have my camera handy...

See if this helps.

[solarbarack]

That is what I need Thanks again Rick.
That would mean Looking at the PC, Black would be upper left, and red lower right. Right?

[SHADiGUY1]

solar i think i may have an extra 9v plug if you need one i can drop it in the mail let me know.

[solarbarack]

Originally Posted by shadiguy1 @ Jun. 05 2008, 9:55 PM

solar i think i may have an extra 9v plug if you need one i can drop it in the mail let me know.

Thank You. Thats great.

[SHADiGUY1]

will be in the mail tommorow.