help with fittings

rickneuhaus

Registered
AHHH! I had my engine apart for about a month doing various mods and putting in a new cam. over that time my sides and front fairings were removed and placed on quilts. now when trying to fit the front to the fairing stay everything lines up and the ram intake vents slide in... but the side fairings no longer align. i can't figure out if it's simply deform of the panels from being off (although i've really got to twist the hell out of the fairings to get them to align; to the point i feel they might break.)

the front aligns with the groove of the intakes: pic

I tried taking out the new mods, even removing the intakes....so finally i loosened up the fairing stay so that i can tilt the whole front end...fits much better but still seems as though the front just isn't going in far enough (about half an inch)

Ideas?!
 
deep breath, make sure you have all your tabs and eerythings in the right place
 
Back
Top