01 gauge prob

1ktobusa

Registered
just got an 01 busa and now the gauges wont do a complete cycle when bike is turned on then they reset them self and do. once its started the tach spedo fuel and temp dont work or read anything and odometer and clock read 8888???? only when its running. tried a new right side handle bar switch and still the same. anyone seen this before or have any ideas? anything will be greatlt appreciated.


thank you
 
Silly comment, but if you haven't already pulled the cluster and check the harness connector and cluster mate - do so; clean the contacts thoughly and check the harness for any frays, cuts or shorts. Also - do the cluster lights come on?
 
yea everything lights up and works like it should with the key on but soon as you put kill switch to run position it starts to act up and when you start it goes blank???
 
just an update incase anyone else has a similar issue. prob fixxed, fuel pump full of rust. cleaned out and cleaned tank. rust was from the tank bein chromed. runs like a raped ape now:thumbsup:
 
Back
Top