I believe it will, the man difference between the 99-01 and the 02+ (limited to gen1) is the early years are a 16bit ecu.
Im for sure no expert, but hopefully one will be along shortly to verify.
Oh and welcome to the Org!
-D
01 is a Mutt all on its own.
No it wont work!
If that is so, its only running at 16 bit, the rotors are different!
If you look under Power Commander, the break down goes as the following
99 to 00
01 to
02 to 07
I have worked on all years, and some parts are Not interchangeable. As well have owned as well.
If that is so, its only running at 16 bit, the rotors are different!
If you look under Power Commander, the break down goes as the following
99 to 00
01 to
02 to 07
I have worked on all years, and some parts are Not interchangeable. As well have owned as well.
Just for the heck of it I'm gonna try an 01 power commander on an 02 up and see what happens.
Lol I got 4 of the 01 pc3 USB's laying around!!
Stock motors don't benefit from a power commands unless you have an aftermarket pipe.
I guess that's possible but from personal experience there was no gain at the track. The numbers might show a little difference on the dyno but the et and mph numbers were identical.With all due respect, very much NOT true. We have installed PCs on totally STOCK Busas and made more power, more torque, better throttle response, midrange, etc.
I was skeptical at the time we did the first one, did the tune at a customer's insistence expecting nothing. One particular stock Gen 1 went from 160 rear to 168 and picked up almost 5 pounds of torque. We realized then how bad the stock tune was for THAT bike. Putting the exact same ecu in every single bike that comes off the assembly line is hit and miss as far as the tune is concerned because of production tolerances and how bad the original tune may have been in the first place. There is no substitute for a proper custom dyno tune . . .
Update - After swapping to a 2005 32bit ECU...the 2001 PC3USB worked fine. I raced it...rode it everywhere and made some dyno pulls. It was definitely working as I had a couple more HP with it on...compared to pulls immediately after taking it off.
Update - After swapping to a 2005 32bit ECU...the 2001 PC3USB worked fine. I raced it...rode it everywhere and made some dyno pulls. It was definitely working as I had a couple more HP with it on...compared to pulls immediately after taking it off.